Hour 10
Intro to Engineering
Allen Sam
Progress on project
Assigning slides for each person to speak and checking checklist for project report.

Comments

Post a Comment

Popular posts from this blog

Image
Day 15  Intro to Engineering Allen Sam 7-3-18 Activities 7.3 and 7.4 7.3 Tolerances 1.       Study the drawings below to identify specified tolerances. a.       Highlight each dimension that has a tolerance associated with it using something like a highlight marker. b.       Identify the type of tolerance in each highlighted example by labeling each tolerance dimension with one of the following: limit dimensions, unilateral tolerance, or bilateral tolerance. c.       Label each identified tolerance with a separate letter, A through Z. d.       Beginning on a new page in your engineering notebook for each part, record the letter of each tolerance identified on that part drawing, the type of tolerance, a short written phase that describes the dimensional variation allowed for that dimension, the tolerance (a number representing the t...
Read more
Image
Day 13 Intro to Engineering Allen Sam 6-28-18 Activity 5.6a Aluminum Object Example 1 1.       What is the volume of the part? A.      1.875 in.³ B.      1.125 in.³ C.     1.375 in.³ D.     2.125 in.³ c.1.375                  2.                                                       What is the density of aluminum in grams per cubic centimeter? (This may require research. Be sure to document your source.)  2.700g/cm^3 3.              ...
Read more
Activity 9.1, 9.2 Design Ethics Intro to Engineering  Allen Sam 7-17-18 Activity 9.1 Product Life cycles Conclusion 1.       What is meant by product lifecycle ?  It is the process of a product being made, used, and perhaps reused. 2.       Why is it important for companies who make products to research and determine a product’s potential lifecycle?  Researching the potential impact of a product life cycle is important because a product may have severe environmental consequences if it is not recyclable or reusable 3.       What would you change about your product? Why?  I would use steel for the L brackets instead of ABS plastic if we were going for a more environmentally friendly approach. The plastics are not very likely to be reused because it is already molded to have a certain purpose. 4.       Do you think your product wi...
Read more